Campbell Scientific HydroSense II Support Software User Guide - Manual (Page 20)

Section 3. Downloading Data
3.2 Connecting to a Device
3.2.1 Connecting
The Connect button controls connection to HydroSense II probes. If a device
is selected in the device list, the Connect button will be enabled.
Press the Connect button to connect to the device. The connection process
should take only a few seconds. The status bar will flash a Connect icon to
indicate that the connection is in progress.
The first time the software connects to a particular HydroSense II, a pairing
step is required. The pairing code is 1234. See
SECTION 3.2.2 Pairing with a
Device (p. 3-3).
If the connection succeeds, an area next to the Connect button expands to show
HydroSense II clock and battery voltage.
The clock icon may be pressed to set HydroSense II time. This will open a
new window. For more information, see
SECTION 3.3 Setting Time (p. 3-5).
If battery voltage is below 4.0 V, the batteries need replacing. The HydroSense
II will turn off if voltage drops to 3.6 V.
During the connection process, the software asks the HydroSense II if it has
any new data or zones. If the connection process is successful, this information
is used to update the status area to the right of the Synchronise button.
Synchronizing data with the device is discussed in SECTION 3.4
Synchronizing with a Device (p. 3-6).
3-2