Campbell Scientific CR7 Measurement and Control System - Manual (Page 50)

SECTION 3. INSTRUCTION SET BASICS
3-8
TABLE 3.9-3. Output Instruction Memory and Execution Times
R = No. of Reps.
INSTRUCTION MEMORY EXECUTION TIME (ms)
INTER. FINAL PROG. FLAG 0 LOW FLAG 0 HIGH
LOC. VALUES1 BYTES
69 WIND VECTOR 2+9R (2, 3, or 4)R 12
Options 00, 01, 02 3.5 + 17.5R 3.5 + 75R
Options 10, 11, 12 3.5 + 16R 3.5 + 30R
70 SAMPLE 0 R 5 0.1 0.4+ 0.6R
71 AVERAGE 1+R R 7 0.9+ 0.5R 2.1+ 3.0R
72 TOTALIZE R R 7 0.6+ 0.5R 1.1+ 1.0R
73 MAXIMIZE (1 or 2)R (1,2,or3)R 8 0.9+ 1.7R 1.3+ 2.8R
74 MINIMIZE (1 or 2)R (1,2,or3)R 8 0.9+ 1.7R 1.3+ 2.8R
75 HISTOGRAM 1+bins*R bins*R 24 0.4+ 3.1R 0.9+
R(3.3+2.8*bins)
77 REAL TIME 0 1 to 4 4 0.1 1.0
78 RESOLUTION 0 0 3 0.4 0.4
79 SMPL ON MM R R 7 0.3 1.1
80 STORE AREA 0 0 5
82 STD. DEV. 1+3R R 7
1Output values may be sent to either Final Storage or Input Storage with Instruction 80.
TABLE 3.9-4. Program Control Instruction Memory and Execution Times
INSTRUCTION MEMORY EXECUTION TIME (ms)
INTER. PROG.
LOC. BYTES
83 IF CASE 0 9 0.5
85 LABEL SUBR 0 3 0.0
86 DO 0 5 0.1
87 LOOP 1 9 0.2
88 IF X<=>Y 0 10 0.6
89 IF X<=>F 0 12 0.4
90 LOOP INDEX 0 3 0.5
91 IF FLAG 0 6 0.2
92 IF TIME 1 11 0.3
93 BEGIN CASE 1 8 0.2
94 ELSE 0 4 0.2
95 END 0 4 0.2
96 SERIAL OUT 0 3
98 SEND CHAR. 0 4