Campbell Scientific CPEC200 Closed-Path Eddy-Covariance System - Manual (Page 93)

Appendix E. Using Swagelok ® Fittings
Tubing inserts
Inserts are recommended for use in plastic tubing. These inserts become
permanently attached to the tubing at the first assembly, so spare inserts may
be needed for replacing the ends of tubing.
FIGURE E-1. Swagelok ® insert
TABLE E-2. Dimensions and part numbers for Swagelok ® inserts
Tubing OD (in) Tubing ID (in) Swagelok ® pn CSI pn
1/4 1/8 B-405-2 15834
1/4 0.17 B-405-170 15830
1/4 3/16 B-405-3 15713
3/8 1/4 B-605-4 9845
1/2 3/8 B-815-6 17380
5/8 1/2 B-1015-8 19495
Ferrules
Each Swagelok ® fitting comes assembled with the front and back ferrules
included. These ferrules are permanently swaged onto the tubing at the first
assembly, so spare ferrules may be needed for replacing the ends of tubing.
Back ferrule Front ferrule
FIGURE E-2. Front and back Swagelok ® ferrules
TABLE E-3. Dimensions and part numbers for Swagelok ® ferrules
Tubing OD (in) Swagelok ® pn (front/back) CSI pn (1 set)
1/8 B-203-1/B-204-1 N/A
1/4 B-403-1/B-404-1 15890
3/8 B-603-1/B-604-1 15889
1/2 B-813-1/B-814-1 N/A
5/8 B-1013-1/B-1014-1 N/A
E-3