MagTek DynaPro Mini Programmer's99875629 - Manual (Page 45)

3 - Command Set
DynaPro Mini| PIN Encryption Device | Programmer’s Reference (Commands)
Page 45
Bit 7 6 5 4 3 2 1 0
Byte 3 Packet length
Byte 4..63 Packet data:
For EMV data, use Tag-Length-Value format [for examples, see section 3.3 About
Commands Tagged As “MAC”]
3.4.19 Report 0x11 – Request Manual Card Entry
This command causes the device to prompt the user to enter the following card information by keypad.
Two modes are available: Account Number mode and Qwick Code mode:
Account Number mode prompts for the following:

Account number (minimum length = 9, maximum length = 19)

Expiration date (minimum length = maximum length = 4)

Card verification code (minimum length = 3, maximum length = 4)
Qwick Code mode prompts for the following:

Qwick Code (minimum length = 8, maximum length = 16)

Last 4 digits of account # (minimum length = maximum length = 4)

Card verification code (minimum length = 3, maximum length = 4)
Figure 3-6 - DynaPro Mini Manual Card Information Entry
An error will be reported in ACKSTS of Report 0x01 – Response ACK if the device status is not OK
(0x8A).
If the command completes successfully, Report 0x22 – Card Status Report will be sent back to the
host. If the host or user cancelled the request, or if the request timed out, byte 1 of Report 0x22 – Card
Status Report will contain the appropriate Operation Status code to indicate why the command did not
complete. Otherwise, if all of the card information was entered correctly, byte 1 = 0x00 (this command
completed OK), byte 2 = 0x00 (Card Status is OK), byte 3 = 0x03 (Card Type is manual), and the host
should send a request to get the card data (see Report 0x0A – Request MSR Data). If Card and
Operation Status are both OK, the host should send a request to get the card data. Report 0x20 – Device
State Report will also be sent back to update the current Device State.
Table 3-23 – Usage Table for Report 0x11
Bit 7 6 5 4 3 2 1 0
Byte 0 0x11