MagTek DynaPro Mini Programmer's99875629 - Manual (Page 37)

3 - Command Set
DynaPro Mini| PIN Encryption Device | Programmer’s Reference (Commands)
Page 37

If Error = 1, the device will not build MS2.0 format track data (if MS2.0 is enabled) if the indicated
track contains error(s).

If Blank = 0, the device will build MS2.0 format track data (if MS2.0 is enabled) if at least one track
contains good data – the indicated track may be blank.

If Blank = 1, the device will not build MS2.0 format Track data (if MS2.0 is enabled) if the indicated
track is blank.
3.4.10 Report 0x09 – Get Device Configuration
This command, when invoked in Get mode, will cause the device to send the current device configuration
to the host in the following report format:
Table 3-10 - Usage Table for Report 0x09 (Get mode)
Bit 7 6 5 4 3 2 1 0
Byte 0 0x09
Byte 1 Device Control (default value = 0x00)
Config
0=unlocked
1=locked Bitmap
0=unlocked
1=locked Tests
Allowed
0=disable
1=enable iAP Config
Allowed
0=unlocked
1=locked Clear
Text
User
Data
0=no
1=yes EMV
Mode
0=Ena
bled
1=Dis
abled MSR
encry
ption
varian
t
0=PI
N
1=DA
TA Requir
e auth
0=no
1=yes
Byte 2 Allow Charging in iAP mode
0x00 = disabled, default
0x01 = enabled
Byte 3 Mask Configuration (default value = 0xC0, all enabled except MS2.0)
ISO Mask
0 = disabled
1 = enabled Check Digit
0 = disabled
1 = enabled MS2.0 Enable
00 = MS2.0 disabled
10 = MS2.0 enabled Track 2 Data Track 1 Data
Error Blank Error Blank
Byte 4 MSR Card Configuration (default value = 0xD5, all enabled)
AAMVA
Card
0 = disabled
1 = enabled Non-finance
card option Track 3 Data Track 2 Data Track 1 Data
00=disabled
01=enabled
11=required 00=disabled
01=enabled
11=required 00=disabled
01=enabled
11=required
Byte 5 Mask Character
Byte 6 Leading length to leave unmasked
In SRED, maximum length = 6
In MS2.0 format, if >8, set to 8; if <5, set to 5 Trailing length to leave unmasked
In SRED, maximum length = 4
Ignored in MS2.0 format