MagTek DynaPro Mini Programmer's99875629 - Manual (Page 36)

3 - Command Set
DynaPro Mini| PIN Encryption Device | Programmer’s Reference (Commands)
Page 36
Bit 7 6 5 4 3 2 1 0
Config
0=unlocked
1=locked Bitmap
0=unlocke
d
1=locked Tests
Allowed
0=disable
1=enable iAP Config
Allowed
0=unlocked
1=locked Clear
Text
User
Data
0=no
1=yes 0 MSR
encrypt
ion
variant
0=PIN
1=DAT
A Requir
e auth
0=no
1=yes
Byte 2 Allow Charging in iAP mode
0x00 = disabled, default
0x01 = enabled
Byte 3 Mask Configuration (default value = 0xC0, all enabled except MS2.0)
ISO Mask
0 = disable
1 = enable Check
Digit
0 = disable
1 = enable MS2.0 Enable
00 = MS2.0 disabled
10 = MS2.0 enabled Track 2 Data Track 1 Data
Error Blank Error Blank
Byte 4 MSR Card Configuration (default value = 0xD5, all enabled)
AAMVA
Card
0 = disable
1 = enable Non-
finance
card option Track 3 Data Track 2 Data Track 1 Data
00=disabled
01=enabled
11=required 00=disabled
01=enabled
11=required 00=disabled
01=enabled
11=required
Byte 5 Mask Character (factory setting is ‘0’)
Byte 6 Leading length to leave unmasked
In SRED, maximum length = 6
In MS2.0 format, if >8, set to 8; if <5, set to 5 Trailing length to leave unmasked
In SRED, maximum length = 4
Ignored in MS2.0 format
Byte 7 EMV L2 ICS Configuration (Default = 0x01)
Note: This setting is ignored when EMV Mode is disabled.
EMV L2 ICS Configuration
0000 = No L2 capability
0001 = Configuration 1C
0010 = Configuration 2C
0011..1111 = Reserved
Byte 8 0x00
Notes for Byte 3, bits 0 – 3:

These four bits can contain any combination of values from 0000 to 1111.

If Error = 0, the device will build MS2.0 format track data (if MS2.0 is enabled) if at least one track
contains good data – the indicated track may contain errors.