MagTek DynaPro Mini Programmer's99875629 - Manual (Page 42)

3 - Command Set
DynaPro Mini| PIN Encryption Device | Programmer’s Reference (Commands)
Page 42
Info ID Key
Status
Data
length
Data Description
0x50 1 9 Keypad sensitivity
Tamper sensitivity
Key on threshold
Key off threshold
4 bytes keypad threshold
Keypad calibration result Keypad values
0x51 1 8 Parameter1 (2 bytes)
Parameter2 (2bytes)
Z ON pen (1 byte)
Z OFF pen (1 byte)
Reserved for future use
(2 bytes) Signature Capture configuration
0x60 –
0x70 1 <=59 SN & subject’s DN** If associated CA cert exists***
0x71 –
0x7F 1 <=59 SN & issuer’s DN** If associated CA cert exists***
0x80 kcv_type=0 4 KCV value KCV**** for Auth key
0x80 kcv_type=1 4 KCV value KCV for PIN key
0x80 kcv_type=2 4 KCV value KCV for MSR key
0x80 kcv_type=3 4 KCV value KCV for fixed PIN key
0x80 kcv_type=4 4 Hash value Dev auth key signed by PIN cert
0x80 kcv_type=5 4 Hash value Dev auth key signed by MSR cert
0x80 kcv_type=7 6 KCV value KCV for MID secret
0x80 kcv_type=9 4 KCV value KCV for Acquirer Master key
0x80 All other
kcv_types 0 KCV****
* lbllen = auth key’s label length
** SN = serial number of cert; DN = distinguished names of subject or issuer of cert; Data length varies
with SN and DN length; max length is 59.
*** its corresponding CA cert
**** KCV = Key Check Value, where the lowest 6 digits are valid