Red Lion PAXR User Manual
Page 31
31
8
Analog Output Parameters - PAXI only
Serial Communication Parameters - PAXI only
PARAMETER
FACTORY
SETTING
USER SETTING
0
ANALOG ASSIGNMENT
ANALOG LOW SCALE VALUE
0
ANALOG HIGH SCALE VALUE
000
ANALOG TYPE
DISPLAY
0
00
000
00
000
00
0
USER SETTING
00
000
00
000
00
FACTORY
SETTING
USER SETTING
FACTORY
SETTING
0
00
000
00
000
00
0
SETPOINT HYSTERESIS (rate)
SETPOINT ASSIGNMENT
USER SETTING
RESET WHEN SPn+1 DEACTIVATES
RESET WHEN SPn+1 ACTIVATES
SETPOINT RESET WITH DISPLAY
COUNTER AUTO RESET ACTION
00
SETPOINT TIME OUT
000
00
SETPOINT ON DELAY
SETPOINT VALUE (B)*
000
00
SETPOINT OFF DELAY
SETPOINT VALUE (A)
STANDBY OPERATION
SETPOINT ACTION
SETPOINT BOUNDARY TYPE
SETPOINT POWER UP STATE
SETPOINT OUTPUT LOGIC
SETPOINT TRACKING
SETPOINT ANNUNCIATORS
FACTORY
SETTING
USER SETTING
FACTORY
SETTING
PARAMETER
DISPLAY
6
Setpoint (Alarm) Parameters
* See Module 2, Exchanging Parameter Lists, for details on programming this value.
Shaded areas are model dependent.
9
Factory Service Parameters
LIMITED WARRANTY
The Company warrants the products it manufactures against defects in materials and workmanship for
a period limited to two years from the date of shipment, provided the products have been stored,
handled, installed, and used under proper conditions. The Company’s liability under this limited
warranty shall extend only to the repair or replacement of a defective product, at The Company’s
option. The Company disclaims all liability for any affirmation, promise or representation with respect
to the products.
The customer agrees to hold Red Lion Controls harmless from, defend, and indemnify RLC against
damages, claims, and expenses arising out of subsequent sales of RLC products or products containing
components manufactured by RLC and based upon personal injuries, deaths, property damage, lost
profits, and other matters which Buyer, its employees, or sub-contractors are or may be to any extent
liable, including without limitation penalties imposed by the Consumer Product Safety Act (P.L.
92-573) and liability imposed upon any person pursuant to the Magnuson-Moss Warranty Act (P.L.
93-637), as now in effect or as amended hereafter.
No warranties expressed or implied are created with respect to The Company’s products except those
expressly contained herein. The Customer acknowledges the disclaimers and limitations contained
herein and relies on no other warranties or affirmations.
DISPLAY
DISPLAY INTENSITY LEVEL
FACTORY
SETTING
USER SETTING
PARAMETER
DISPLAY
PARAMETER
FACTORY
SETTING
USER SETTING
COMMUNICATIONS TYPE
Mbrtv
BAUD RATE
800
DATA BIT
8
PARITY BIT
METER ADDRESS
TRANSMIT DELAY
000
ABBREVIATED PRINTING
PRINT COUNTER A
PRINT COUNTER B
PRINT COUNTER C
PRINT RATE
PRINT MAX & MIN
PRINT SCALE FACTORS
PRINT COUNT LOAD VALUES
PRINT SETPOINT VALUES