Outback Power Systems FLEXpower ONE One Fully Pre-Wired Single Inverter System Installation Manual - Manual (Page 61)

900-0095-01-00 Rev A
59
Wiring Configurations
The following wiring configurations are provided as examples only. Actual wiring requirements may
vary depending on local electric code. All installations must comply with local electric code.
 FLEXpower ONE with FLEXnet DC Monitor and GFDI
 FLEXpower ONE with FLEXnet DC Monitor Only (No GFDI)
 FLEXpower ONE with GFDI Only (no FLEXnet DC Monitor)
 FLEXpower ONE (no FLEXnet DC Monitor or GFDI)