Outback Power Systems FLEXpower ONE One Fully Pre-Wired Single Inverter System Installation Manual - Manual (Page 44)

Operation
Selecting the AC Source and AC Input Limit on the Inverter
IMPORTANT:
The AC Input limit should NOT exceed the rating
of the overcurrent protection for the device.
DEC: Pressing this soft key decreases the value.
INC: Pressing this soft key increases the value.
AC2 GEN Menu:
Adjusts the maximum current the inverter will
draw from the generator for either supporting
loads or battery charging (between 2.0 Aac and
60.0 Aac).
AC1 GRID Menu:
Adjusts the maximum current the inverter will
draw from the grid for either supporting loads or
battery charging (between 5.0 Aac and 60.0 Aac).
The <Port> Soft Key switches between
ports on the HUB (i.e., between multiple
inverters if installed).
Figure 29 Inverter Setup Screen – Selecting AC Source
42
900-0095-01-00 Rev A