beautypg.com

Figure 25, Replacing the dc enclosure front cover, Figure 26 – Outback Power Systems FLEXpower ONE One Fully Pre-Wired Single Inverter System Installation Manual User Manual

Page 39: Replacing the dc cover, Installation

background image

Installation

DC Enclosure

Front Cover

Lip

Notch

1. Align the holes in the DC Enclosure Front cover

with the holes in the chassis. Ensure that the
“lip” fits into the notch in the chassis.

2. Replace the screws removed in the beginning.

To Replace the DC Enclosure Front Cover:

Cabling not shown.

Figure 25

Replacing the DC Enclosure Front Cover

DC Cover

3. Replace the screws removed in the beginning.

2. Align the holes in the DC Cover as shown.

To Replace the Inverter’s DC Cover:

1. Replace the plastic Battery Terminal Covers.

Cabling not shown.

Figure 26

Replacing the DC Cover

900-0095-01-00 Rev A

37

See also other documents in the category Outback Power Systems Power suppliers: