Outback Power Systems FLEXpower ONE One Fully Pre-Wired Single Inverter System Installation Manual - Manual (Page 19)

Planning
900-0095-01-00 Rev A
17
Preparation
Tools Required
The following tools may be required for installing this equipment.
 Wire cutters/strippers  Drill and drill-bits
 Torque wrenches  Ratchet drives
 Assorted insulated screw-drivers  Digital Voltmeter
Materials Required
The following materials may be required for installing this equipment.
 Conductors for wiring
 Conduits, bushings
 Anchor Bolts (x4) or Dry-wall (x6) screws for mounting
 Plywood (optional, for additional wall support)
Accessories
The following accessories are available for purchase.
 PV8/PV12 Combiner Box
 See the OutBack catalog for a complete list of other parts and components that are available.
Location
 FLEXpower ONE is rated for indoor installations.
 In areas where seismic activity is a concern, consult local code for seismic safety requirements.
Environmental
 This unit is performance rated at 25°C (77°F). Exposure to extreme hot temperatures can reduce
the unit’s performance. When used in an outdoor installation, use a shading structure to avoid
direct exposure to sunlight.
 The mounting surface should be vertical, smooth, and able to support three (3) times the weight
of the enclosure (98 lb, or 44.5 kg. This may require additional support for wall-mounted
installations.