beautypg.com

Figure 10, Installation – Outback Power Systems FLEXpower ONE One Fully Pre-Wired Single Inverter System Installation Manual User Manual

Page 25

background image

Installation

Lift the Mounting Plate
above the wall bracket.

Secure the Mounting Plate to the

wall at the 3 locations shown

below.

Slip the top of the
Mounting Plate over
the angled lip of the
wall bracket.

Secure the Mounting Plate to the wall

at the 3 locations shown here.

Figure 10

Attaching the Mounting Plate to the Mounting Bracket

900-0095-01-00 Rev A

23

See also other documents in the category Outback Power Systems Power suppliers: