Outback Power Systems FLEXpower ONE One Fully Pre-Wired Single Inverter System Installation Manual - Manual (Page 42)

Operation
Setting Time, Date & Display on the MATE2
IMPORTANT:
The following information assumes the installer is familiar with the basic
operation of a MATE2 System Controller and Display. If the installer is not familiar
with basic operation, please refer to the MATE Installation and User Manual for
general information.
MATE2 Setup
Screen PG 2 and
PG 3 are shown
on page 41
Figure 27 MATE2 Setup Screen (Page 1)
40
900-0095-01-00 Rev A