Outback Power Systems FLEXpower ONE One Fully Pre-Wired Single Inverter System Installation Manual - Manual (Page 38)

Installation
Cabling not shown.
2. Replace the screws (x4) removed in the beginning.
1. Align the holes (x4) in the enclosure front cover
with the holes in the chassis.
To Replace the Front of AC Enclosure:
The Front Cover of the AC Enclosure will not be
completely removed due to the surge protector
cabling. Work with care not to damage the
surge protector or dislodge the cabling as you
replace the Front Cover.
Figure 23 Replacing the AC Enclosure Front Cover
Cabling not shown.
To Replace the Top of AC Enclosure:
1. Slip the Lip on the AC Top Cover into the notch in
the chassis.
2. Align the holes (x2) in the top cover with the holes
in the front cover.
2. Replace the screws (x2) removed in the beginning.
AC Top Cover Lip
Notch
Figure 24 Replacing the AC Enclosure Top Cover
36
900-0095-01-00 Rev A