Outback Power Systems FLEXpower ONE One Fully Pre-Wired Single Inverter System Installation Manual - Manual (Page 14)

Introduction
12
900-0095-01-00 Rev A
Components
A complete FLEXpower ONE is composed of the following components. See page 49 for details on
specific configurations.
Table 2 Basic Components of a FLEXpower ONE System
Components Documentation
FX Series Inverter/Charger (VFX or GVFX) FLEXpower ONE Installation Manual (this book)
Mounting Plate (with mounting bracket)
MATE Remote Control and Display
AC Enclosure (120 V-NA or 230 V-EU) Additional Reference Documents
DC Enclosure (125, 175, or 250A) MATE Installation and User’s Manual
FLEXnet DC Battery Monitor FLEXnet DC Monitor
FLEXmax 80 Charge Controller FX or Grid-Interactive Programming Manual
Raceway FLEXmax 80 User’s Manual
HUB4 Communication Manager HUB4 Communication Manager User’s Manual
FLEXware Surge Protector
FLEXnet DC Battery Monitor
FW250-AC-120V-NA
Or
FW250-AC-230V EU
FX Series
Inverter/Charger
FW250-DC-125,
FW250-DC-150,
or
FW250-DC 250
HUB4 Communication Manager
FLEXmax 80 Charge Controller
Mounting Plate
MATE2 Remote Control
Raceway
FLEXware Surge Protector
(mounted under AC cover)
Figure 2 Basic Components of a FLEXpower ONE System