Outback Power Systems FLEXpower ONE One Fully Pre-Wired Single Inverter System Installation Manual - Manual (Page 27)

Installation
Accessing the Wiring Compartments
Inverter Terminal Enlargement Internal components may vary from model to model.
Factory wiring is not shown.
AC Input, Output, & Bypass
Breakers (x3)
(120-NA: 60 A)
(230 EU : 30 A)
Mechanical Interlock
Breaker for AC Outlet (X1)
120-NA: 20 A
23-EU: 16 A
AC Outlet (X1)
Terminal Bus Bar for
Neutral Connections
AC Ground Bar
DC Ground Bar
Battery Disconnect
(125, 175, or 250 Adc)
GFDI Breaker (1 Adc)
PV Disconnect (80 Adc)
Battery Positive (+)
Battery Negative (–)
Breaker for FNDC (1 A)
(if installed)
Shunt A 1
1 Required by FLEXnet DC Monitor. Shunt A monitors inverter input and output
current. Shunt B monitors PV input current. Shunts are not present if the
FLEXnet DC Monitor is not part of the configuration. Shunt B is not present if the
FLEXmax 80 Charge Controller is not part of the configuration.
Shunt B 1
FLEXmax 80
Terminal Block
Enlargement
FLEXnet DC Monitor
(If installed)
Figure 12 Wiring and Breaker Compartments
900-0095-01-00 Rev A
25