Reassembling the enclosures, Figure 21, Replacing the raceway and flexmax 80 front cover – Outback Power Systems FLEXpower ONE One Fully Pre-Wired Single Inverter System Installation Manual User Manual

Page 37: Figure 22, Replacing the inverter’s ac terminal access cover, Installation

Installation

Reassembling the Enclosures

Lip

Slot

Raceway

FM80

Front

Cover

Cabling not shown.

Mounting

Panel

To Replace the Raceway:

1. Slip the lip on the Raceway into the

slot on the mounting panel.

2. Align the holes on the bottom of

the Raceway with the holes
provided on the mounting panel.

3. Secure the Raceway in place with

the screws provided.

To Replace the FLEXmax 80
Front Cover:

1. Align the holes on the FM80

Front Cover.

2. Secure the FM80 Front Cover in

place with the screws provided.

Figure 21

Replacing the Raceway and FLEXmax 80 Front Cover

Cabling not shown.

Inverter’s AC Terminal

Access Cover

To Replace the Inverter’s AC
Terminal Access Cover:

1. Align the holes on the sides of the

cover with the holes on the inverter.

2. Secure the cover in place with the

screws provided.

Figure 22

Replacing the Inverter’s AC Terminal Access Cover

900-0095-01-00 Rev A