DAVIS Weather Monitor II (7440, 7440CS) - Manual (Page 37)

Total Clear
Weather Monitor II Page 33
To Clear an Alarm
1. Since the function triggering the alarm is already on the display, simply press ALARM
once or twice to get the desired alarm setting (high or low) for that function.
If more than one alarm is sounding, wait until the function you want to clear
appears before you press ALARM.
2. Press and hold down CLEAR until the display shows a series of dashes.
C LEARING AN A LARM
3. Press any key to exit.
Note: Each alarm setting is independent of every other. For instance, clearing the high inside tempera-
ture alarm does not clear the low inside temperature, high outside temperature, or low outside
temperature alarms. You must clear each alarm individually.
T
OTAL
C
LEAR
The total clear function automatically clears all of the high and low readings as
well as the stored barometric pressure at the same time.
The following functions are reset by the total clear function:
• High and Low Inside Temperatures
• High and Low Outside Temperatures
• Stored Barometric Pressure
• High and Low Inside Humidities
• High and Low Outside Humidities
• High and Low Dew Point
• High Wind Speed
• Low Wind Chill
The following functions are not reset by total clear:
• Time
• Date
• Current Barometric Pressure
• Daily and Accumulated Rainfall
• Barometric Trend
• Alarm Settings
MPH
N
NE
SW
NW
SE
E W
S
OUTSIDE LOW
BAROMETRIC
TREND
HUMIDITY
ALARM