DAVIS Weather Monitor II (7440, 7440CS) - Manual (Page 35)

Alarms
Weather Monitor II Page 31
If more than one alarm is sounding at once, the Weather Monitor II will scan
through all of the triggered alarms, displaying each for approximately four sec-
onds before moving to the next.
T YPICAL A LARM D ISPLAYS
To Display an Alarm Setting
1. Press the appropriate key to display the function you desire.
For temperature and humidity you must choose between the inside and outside
readings, as each set of alarms is handled separately.
2. Press UNITS to select the desired unit of measure.
3. Press ALARM.
If you are displaying temperature or humidity, which have two alarm settings
each, the high alarm setting appears first.
4. To display the low alarm setting for temperature or humidity, press ALARM again.
To Set an Alarm
1. Press the appropriate key to display the function you desire.
2. Press UNITS to select the desired unit of measure.
3. Press ALARM until the alarm setting you desire appears on the display.
4. Use ENTER to set the alarm (see “Using the Enter Key” on page 16 for instructions).
5. Press any key to exit.
Example of Setting an Alarm—Low Outside Temperature Alarm
Suppose you wanted to set the Weather Monitor II alarm to sound when the
outside temperature dropped below 40˚F.
1. Press TEMP once or twice until outside temperature is displayed.
2. If necessary, press UNITS to change to ˚F.
Using the 1˚F resolution is probably easiest, though you can set the alarm to 1˚ or
0.1˚ resolution for either Fahrenheit or Celsius.
F
MPH
N
NE
SW
NW
SE
E W
S
OUTSIDE LOW
BAROMETRIC
TREND
TEMPERATURE
ALARM
MPH
N
NE
SW
NW
SE
E W
S
LOW
BAROMETRIC
TREND
C
WIND CHILL
ALARM
MPH
N
NE
SW
NW
SE
E W
S
INSIDE
HIGH
BAROMETRIC
TREND
HUMIDITY
ALARM
MPH
N
NE
SW
NW
SE
E W
S
HIGH
SPEED
BAROMETRIC
TREND
ALARM
High Wind Speed Alarm: 30 mph
Low Outside Temp Alarm: 32.0˚F
High Inside Humdity Alarm: 50%
Low Wind Chill Alarm: 0˚C