DAVIS Weather Monitor II (7440, 7440CS) - Manual (Page 32)

Using the Weather Functions
Page 28 Weather Monitor II
2. To display outside humidity, press HUM again.
The outside humidity reading and the word OUTSIDE appear on the display.
H UMIDITY D ISPLAYS
To Display High and Low Humidities
1. Press HUM once or twice to select inside or outside humidity, as desired.
2. Press RECL to display the high.
After a few seconds, the display will show the time the high was recorded, and
then the date it was recorded.
3. Press RECL again to display the low.
After a few seconds, the display will show the time the low was recorded, and
then the date it was recorded.
4. Press any key to exit.
To Clear High and Low Humidities
1. Press HUM once or twice to select inside or outside humidity, as desired.
2. Press RECL once or twice to select the high or low humidity, as desired.
3. Press CLEAR and hold it down.
The display will flash several times, and then the old reading will be replaced by
the current humidity. As the humidity rises and falls, the high and/or low will be
updated.
4. Press any key to exit.
Note: High and low humidities are independent of each other. Clearing the high humidity does not clear
the low humidity, and vice versa. You must clear each individually.
To Use the High and Low Humidity Alarms
For instructions on how to use the high and low humidity alarms, see
“Alarms” on page 30.
MPH
N
NE
SW
NW
SE
E W
S
OUTSIDE
BAROMETRIC
TREND
HUMIDITY
MPH
N
NE
SW
NW
SE
E W
S
INSIDE
BAROMETRIC
TREND
HUMIDITY
Outside Humidity: 65% Inside Humidity: 26%