DAVIS Health EnviroMonitor: Console - Manual (Page 38)

Using the Health EM
Page 46 Health EnviroMonitor Manual
4. Press any function key to exit.
Each alarm threshold is independent of every other. For instance, clearing
the high air temperature alarm does not clear the low air temperature alarm.
You must clear each alarm individually
E NABLING /D ISABLING A UTO C LEAR
The general procedure for enabling and disabling the AutoClear function for
individual weather conditions is covered below.
1. Press the appropriate key(s) to display the desired weather condition’s AutoClear dis-
play.
T YPICAL A UTO C LEAR S TATUS
2. Press ENTER to alternate the status between on and off.
3. Press any function key to save and exit.
G ENERAL H IGH /L OW C LEAR
The Health EM includes a general clear feature which enables you to quickly
clear most of the high and low registers. The general clear feature, however,
will not clear any high/low value for which AutoClear (see “AutoClear” on
page 12) has been turned on.
The following registers are cleared by the general clear feature:
• High Outside and Inside T-H Index
• High Outside T-H-S-W index
• Low Wind Chill
• High and Low Outside and Inside Temperature
• High Wind Speed
• High Solar Radiation Intensity
• High and Low Outside Humidity
The following registers are NOT cleared by the general clear feature:
• “Daily” UV Radiation Dose
• Accumulated UV Radiation Dose
• “Daily” Rainfall
• Total Rainfall
• High Rate of Rainfall