DAVIS Health EnviroMonitor: Console - Manual (Page 10)

Using the Health EM
Page 18 Health EnviroMonitor Manual
Viewing Apparent Temperature
1. To display the current outside T-H index, press HEAT STRESS.
The current outside T-H index appears on the right of the display.
C URRENT O UTSIDE T-H I NDEX
2. To display the current outside T-H-S-W index, press HEAT STRESS again.
The current outside T-H-S-W index appears on the right of the display.
C URRENT T-H-S-W I NDEX
Note: If the station does not have a solar radiation sensor, the SUN segment will be absent from the
display. Likewise, if the station does not have an anemometer, the WIND segment will be absent
from the display.
3. To display the current inside T-H index, press HEAT STRESS.
The current inside T-H index appears on the right of the display.
C URRENT I NSIDE T-H I NDEX
4. To display the status of the AutoClear function for high outside T-H index, high outside
T-H-S-W index, and high inside T-H index, press HEAT STRESS again.
If the AutoClear function is enabled, the word O n appears on the right of
the display. If the AutoClear function is disabled, the word O F F appears
on the right of the display. (See “Enabling/Disabling AutoClear” on page 46
for instructions.)
Note: You cannot enable/disable the AutoClear function separately for outside T-H index, outside
T-H-S-W index, and inside T-H index. These functions are “linked” and AutoClear for them must
be either enabled or disabled together.