DAVIS Health EnviroMonitor: Console - Manual (Page 26)

Using the Health EM
Page 34 Health EnviroMonitor Manual
3. To display the status of the AutoClear function for daily rainfall and for the high rate of
rainfall, press RAIN again.
If the AutoClear function is enabled, the word O n appears on the right of
the display. If the AutoClear function is disabled, the word O F F appears
on the right of the display. (See “Enabling/Disabling AutoClear” on page 46
for instructions.)
Note: You may not enable/disable the AutoClear function separately for daily rainfall and high rate of
rainfall. These two functions are “linked” and AutoClear for them must be either enabled or dis-
abled together.
4. Continuing to press RAIN will cycle through the rain displays in a continuous loop.
Selecting Units of Measure
To select the desired unit of measure, simply press UNITS while viewing any of
the rainfall displays (except AutoClear). As you press UNITS, the Health EM
alternates between inches and millimeters. Rate of rainfall switches from
inches per hour to millimeters per hour automatically.
S AMPLE U NITS OF M EASURE
Entering Total Rainfall
You may have previously recorded rainfall amounts which you want reflected
in the Health EM’s total rainfall amounts. Use the procedure below to enter a
total rainfall amount.
1. Press RAIN as necessary to display total rainfall.
2. Use ENTER to set the desired amount of total rainfall.
See “Using the Enter Key” on page 15 for instructions on using ENTER.
3. When finished entering the total rainfall amount, press RAIN.
The Health EM saves the total rainfall amount. The system will add any fur-
ther rainfall to this total, until you clear total rainfall.