DAVIS Health EnviroMonitor: Console - Manual (Page 33)

Highs and Lows
Health EnviroMonitor Manual Page 41
3. To view the time at which the high/low occurred, watch the display without pressing a
key.
After approximately four seconds, the time at which the high/low occurred
will appear on the right of the display. As long as you do not press a key, the
Health EM will continuously alternate between the high/low reading and
the time.
4. If a function stores/displays both a high and a low, press Recall again to view the low.
The low reading appears on the right of the display.
5. To view the time at which the low occurred, watch the display without pressing a key.
After approximately four seconds, the time at which the low occurred will
appear on the right of the display. As long as you do not press a key, the
Health EM will continuously alternate between the low reading and the
time.
Clearing Highs and Lows
Clearing a high or a low value erases the currently stored value in order to
obtain a new high/low reading.
1. Press the appropriate key as necessary to display the desired weather condition.
2. Press RECALL as necessary to display the high or low for that condition.
3. Press and hold down CLEAR until the high/low value is cleared.
When the value stops flashing it means that the high/low has been cleared.
It is not uncommon for another high/low reading to appear almost immedi-
ately. This is simply because the Health EM is constantly in the process of
recording new highs and lows.
4. Press any function key to exit.
Each high/low is independent of every other. For instance, clearing the high
air temperature does not clear the low air temperature. You must clear each
individually.