Additional obd2 tests, Non-continuous test – Equus 3140 - Scan Tool CanOBD2&1 Kit User Manual
Page 55

CanOBD2&1
53
E
Additional OBD2 Tests
NON-CONTINUOUS TEST
5. When you have finished viewing the
retrieved test data, scroll to the end of
the display to select Exit, then press the
ENTER/LD
button to return to the
"Select Test" screen.
NON-CONTINUOUS TEST
The Non-Continuous Test function retrieves and displays test results
for emission-related powertrain components and systems that are not
continuously monitored. The tests available are determined by the
vehicle manufacturer.
The CanOBD2&1 Scan Tool does not perform non-continu-
ous test, but retrieves results from the most recently per-
formed tests from the on-board computer’s memory. You may
retrieve non-continuous test results for only one test at any
given time.
1. From the "Mode Selection Menu", use the
UP
and DOWN
buttons, as nec-
essary, to highlight Non-Continuous Test,
then press the ENTER/LD
button.
■
The “Select Test” screen displays.
The screen shows all tests applicable
to the vehicle under test. Refer to the
vehicle’s service repair manual for
infor-mation related to non-continu-
ous tests.
If non-continuous tests are not
supported by the vehicle under
test, an advisory message shows
on the CanOBD2&1 Scan Tool's
display. Press the ENTER/LD
button to return to the Mode
Selection menu.
2. Use the UP
and DOWN
but-
tons, as necessary, to highlight the
desired test, then press the ENTER/LD
button.
3. A “One moment please. . .” message diplays while the request is
sent to the vehicle’s on-board computer.
4. When test results have been retrieved, data for the selected test will show
on the CanOBD2&1 Scan Tool’s display. The display shows the follow-
ing information: