Equus 3140 - Scan Tool CanOBD2&1 Kit - Manual (Page 48)

Generic (Global) OBD2 PID List
46 CanOBD2&1
E
■ If the Code Reader is connected to a vehicle, use the DOWN
button to scroll to the end of the PID list, highlight Exit Playback,
then press the ENTER/LD button.
■ If the Code Reader is not connected to a vehicle, press the DTC
SCROLL button.
The following is a list of Generic (Global) PIDs and their descriptions.
Tool
Display
Unit Value PID Description
ACC Pedal D % XXX.X Accelerator Pedal Position D
ACC Pedal E % XXX.X Accelerator Pedal Position E
ACC Pedal F % XXX.X Accelerator Pedal Position F
Air Status - UPS, DNS, Commanded Secondary Air
OFF Status
Ambient *C / *F XXX Ambient Air Temperature
Aux Input Status - On / Off Auxiliary Input Status
BARO kPa / XXX / XX.X Barometric Pressure
inHg
Calc LOAD % XXX.X Calculated LOAD Value
CAT Temp 11 *C / *F XXXX.X Catalyst Temperature Bank 1-
Sensor 1
CAT Temp 12 *C / *F XXXX.X Catalyst Temperature Bank 1-
Sensor 2
CAT Temp 21 *C / *F XXXX.X Catalyst Temperature Bank 2-
Sensor 1
CAT Temp 22 *C / *F XXXX.X Catalyst Temperature Bank 2-
Sensor 2
Command % XXX.X Commanded EGR
EGR
Command % XXX.X Commanded Evaporative Purge
EVAP
Command TAC % XXX.X Commanded Throttle Actuator
Dist DTC Clr km / XXXXX Distance since DTC Cleared
mile
Dist MIL ON km / XXXXX Distance Traveled while MIL ON
miles
ECT *C / *F XXX / XXX Engine Coolant Temp
ECU Volts V XX.XXX Control Module Voltage
EGR Error % XXX.X EGR Error
Eng RPM min XXXXX Engine RPM
EQ Ratio - X.XXX Commanded Equivalence Ratio