Equus 3140 - Scan Tool CanOBD2&1 Kit - Manual (Page 45)

OBD2 Live Data Mode
RECORDING (CAPTURING) LIVE DATA
CanOBD2&1 43
E
■ A "One moment please. . ." message
shows on the display. When the
CanOBD2&1 Scan Tool is ready to
record Live Data, the "Record Live
Data" screen displays.
7. Put the engine in the operating condition
where the problem manifests itself.
■ If necessary, drive the vehicle until you reach the vehicle speed
at which the problem occurs.
8. When the problem occurs, press and
release the ENTER/LD button.
■ All three LEDs will blink for three sec-
onds to indicate that Live Data is
being recorded, and a "One moment
please. . ." message shows on the
display.
■ When recording is complete, a confir-
mation screen displays, asking if you
would like to view the recorded data.
Use the UP and DOWN but-
tons, as necessary, to select Yes or
No, as desired, then press the
ENTER/LD button.
If Yes is selected, the CanOBD2&1 Scan Tool enters
"Playback" mode from which you can view a frame-by-frame
playback of recorded Live Data (see Live Data Playback on
page 44 for details). If No is selected, the display returns to
the "Live Data View" mode.
9. You can exit the "Record Live Data Mode" at any time by pressing
and holding the ENTER/LD button until the "Mode Selection
Menu" displays.
If desired, you can transfer the recorded Live Data information
to a personal computer using the optional PC-LINK program
(see instructions included with PC-Link for more information).
Important Information
1. When Live Data capture is complete, the green, yellow and red LEDs
on the CanOBD2&1 Scan Tool will flash four times to indicate that
Live Data is being saved to the CanOBD2&1 Scan Tool's memory.
2. When you are LINKED to a vehicle and you are in the “Live Data
View mode”, you can toggle between “Live Data View” mode and
“DTC view” mode by alternately pressing and releasing the DTC