Equus 3140 - Scan Tool CanOBD2&1 Kit - Manual (Page 10)

About the CanOBD2&1 Scan Tool
ADJUSTMENTS/SETTINGS AND DTC LIBRARY
8 CanOBD2&1
E
If a definition for the DTC you
entered is not available, an advi-
sory message shows on the
CanOBD2&1 Scan Tool’s display.
4. If you wish to view definitions for addi-
tional DTCs, press the ENTER/LD
button to return to the DTC Library
screen, and repeat steps 2 and 3.
5. When all desired DTCs have been viewed, press the ERASE
button to exit the DTC Library and return to the Setup Menu.
Selecting the Display Language
1. Use the UP and DOWN buttons, as necessary, to highlight
Select Language in the Setup Menu, then press the ENTER/LD
button.
■ The Select Language screen dis-
plays.
■ The currently selected display
Language is highlighted.
2. Press the UP or DOWN button,
as necessary, to highlight the desired
display language.
3. When the desired display language is
highlighted, press the ENTER/LD
button to save your changes and return
to the Setup Menu.
Setting the Unit of Measurement
1. Use the UP and DOWN but-
tons, as necessary, to highlight Unit of
Measure in the Setup Menu, then
press the ENTER/LD
button.
2. Press the UP or DOWN button,
as necessary, to highlight the desired
Unit of Measure.
3. When the desired Unit of Measure
value is selected, press the ENTER/LD
button to save your changes and
return to the Setup Menu.