Ag Leader GPS 2500/2500B Operators Manual - Manual (Page 41)

35
GPS 2500B
M
ENU
M
AP
Base Station Tab
The Base Station tab allows you to set up multiple base station
locations and manually set the reference station locations stored in
the receiver. The 2500B supports up to 32 base station coordinates.
The receiver must be running the SBASRTKB application and you
must have an RTK subscription for the function to be enabled.
Upon connecting to the receiver, Remote Control automatically
queries the receiver for its list of known coordinates.
After a successful query Remote Control displays a list of existing
base station coordinates. If the receiver has converged on a
reference point, the converged coordinates will appear with a * next
to the #, as seen below.
Coordinates list
Converged reference point
Once the coordinates list is populated you can perform the following
tasks:
• Add coordinates
• Import or export coordinates
• Delete coordinates
Note: You must click the Save button before exiting Remote Control to save your changes (adding,
deleting, and importing coordinates).
If you do not want the receiver to have the base station coordinate list active, clear the Enable Base
Station List check box.
You can change the coordinate format between decimal degrees (DD.D), degrees and decimal minutes
(DM.M), or degree minutes and decimal seconds (DMS). Any change to this value also affects the
coordinates displayed on the LCD.