Ag Leader PF3000 Cotton Yield Monitor Operators Manual - Manual (Page 18)

PF3000 Cotton Yield Monitor
Console Setup Ag Leader Technology
March 2002 2-4
Operating mode At this time, Cotton Harvest and Site Verification is the only operating
mode available with the PF3000 Cotton Yield Monitor System. To use the
PF3000 for grain harvest or app rate, a different operating program is
available.
Units of measure The units of measurement for the PF3000 Cotton Yield Monitor are
Imperial or Metric.
Month/Day/Year Use the LEFT or RIGHT ARROW keys to move from month to day to year.
Use the UP or DOWN ARROW keys to change the value. The whole
month, day or year is highlighted and only the last digit increments. Press
LEFT or RIGHT ARROW to set to item to be edited.
Time 12 Hour Clock with AM/PM. The whole hour (2 digits) or minutes value (2
digits is highlighted when editing. AM changes to PM when incrementing
by 12. Press LEFT or RIGHT ARROW to set to item to be edited. If you
are using metric units of measure the 24 hour clock is used.
Serial number,
Box calibration,
Voltage calibration The serial number, box calibration number and voltage calibration number
can be found on the bottom side of the monitor. These numbers should be
set correctly from the factory.
GPS Check Sum If you are using a GPS receiver with the PF3000 the GPS Check Sum setting
is used to enable or disable data string error checking.
NOTE: For all Ag Leader receivers (GPS 2000/2100, Add-on GPS
3000/3100), and Trimble 120,122,132 receivers the GPS Check Sum should
be set to ON.
For most other brands of GPS receivers the GPS Check Sum should also be
set to ON. If you can not get a "D" and "G", though, set this setting to OFF.
Field Marker If you are… Select
Marking field points with the PF3000’s internal
marker selection keys. INTERNAL
Marking field points with an external Ag Leader
Field Marker. EXTERNAL
* * *