Ag Leader PFadvantage Advanced Light Bar Operators Manual - Manual (Page 19)

Light Bar General Operation
Ag Leader Technology
Basic A-B Parallel
Swathing using
AUTO or Snap
Use this type of pattern when no headlands are required and the field is
going to be driven in a straight parallel swath pattern. Refer to the PF
monitor Setup for Guidance Section on page 23 for the procedures to
set the following:
Pattern: Set to NONE
Headland Type: Set to NONE
Swath Direction: Set to AUTO or SNAP
Look – Ahead, Display Mode, Swath Width and Units Display should
be established to your preference or situation.
Before making your first pass:
Press MENU key until OPTIONS is displayed and press OPTIONS
key.
Press the LIGHTBAR key.
Press the RESET key to clear all points in memory.
NOTE: Before working in a new field, you should reset the system
to clear previous field information.
When you begin your first pass, press SET A key. (See Figure 11.)
At the end of the first pass press SET B key.
NOTE: SET B cannot be set without first setting SET A.
February 2003 Rev.3 3000135 15