Ag Leader PFadvantage Advanced Light Bar Operators Manual - Manual (Page 14)

General Information Light Bar
Ag Leader Technology
Auto: Automatically increments in the direction
turned after the first swath. The swath
increments when the vehicle turns more than
110 degrees.
Right: Swaths are manually incremented to the
right of the A-B line.
Left: Swaths are manually incremented to the left
of the A-B line.
Snap: Automatically increments swath
number to the closest swath. (Not availabe
with Pass Skip and Curve following.) This is
the default setting.
Swath Width: Adjust in .5 ft increments from 1 to 999 ft. Set the
swath width to 1 ft less than the actual swath width to
reduce skip. Set the swath width 1 ft more than the
actual swath to reduce overlap.
Antenna Offset: The distance from the antenna, ahead or behind the
spray boom so that guidance information is
referenced to the spraying boom instead of the
antenna. It is adjusted in .5 ft increments from 0 to
100 ft. The antenna must be placed along the
vehicle’s centerline. Negative numbers are used for
a boom in front of the antenna, positive numbers are
for a boom behind the antenna.
Pass Skips: Adjusted in 0 to 99.
Units Displayed: Determines whether Metric or US Standards
(English) are used. The default is Metric.
Contour Log Interval: The settings are Swath Change and Heading
Change. Heading change is the default and
recommended setting. With the Contour Log
Interval set to Heading Change a reference
point will be logged whenever the heading
changes slightly.
February 2003 Rev.3 3000135 10