Ag Leader PFadvantage Advanced Light Bar Operators Manual - Manual (Page 6)

Installation Light Bar
Ag Leader Technology
Installing Light
Bar IMPORTANT: The Light Bar must be mounted inside the cab
of your vehicle. The Light Bar is not resistant to weather
elements on the outside of the vehicle and could be damaged if
mounted outside of the cab.
1. Determine a location on the dash or ceiling to mount the Light Bar.
The Light Bar should be positioned within your peripheral vision.
2. Use an upright position for dash mounting and inverted for ceiling
mounting.
NOTE: Mounting the Light Bar on the ceiling inverts the Light Bar
text and requires a SETUP change.
3. Mounting the Light Bar bracket may be done by using three
methods: Dual-Lock strips, mounting hardware or the Optional
Suction cup. Select one of the methods below to mount the
bracket.
a. Bracket mounting with Dual-Lock strips:
(1) Clean the surface of the mounting location with
provided alcohol swabs.
(2) Remove the peel off strip from the Dual-Lock strip
on the back of the Light Bar bracket.
Do not touch the adhesive surface of the strip.
(3) Press the Light Bar bracket to the mounting location
determined in Step 1. Press the bracket firmly or
gently pound on the bracket to bond the adhesive
strip.
NOTE: The two additional Dual-Lock strips are for
replacement of the bracket strip or to add additional
mounting locations in the cab.
b. Bracket mounting with hardware:
(1) Using the mounting bracket as a template, mark the
three bracket holes for the position you determined
in Step 1.
(2) Use a 3/16-in. drill bit to drill the holes.
February 2003 Rev.3 3000135 2