HP ProLiant ML350e Gen8 Server - Manual (Page 94)

Hardware options installation 94
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
o For tower models, place the server on a flat, level surface with the access panel facing up.
o For rack models, extend the server from the rack (on page 27 ).
5. Remove the access panel (on page 25 ).
6. Remove PCI air baffle (" Remove the PCI air baffle " on page 28 ), if installed.
7. Remove the system air baffle (on page 30 ).
8. Install an optional Smart Array controller (" Installing an expansion board " on page 77 ).
9. Remove any installed full-length PCI cards.
10. Remove the fan cage (on page 31 ).
11. Disconnect the existing SAS cable from the system board connector.
12. Connect the SAS cables:
a. Connect the mini-SAS cable that came with the kit to the empty SAS connector on the drive
backplane.