Optical drive option – HP ProLiant ML350e Gen8 Server User Manual
Page 66

Hardware options installation 66
The Torx screws required to install optical drives are located on the chassis.
9.
For tower models, do the following:
a.
Install the access panel (on page
b.
Return the server to an upright position.
10.
For rack models, do the following:
a.
Install the rack bezel (on page
b.
Install the access panel (on page
c.
Slide the server back into the rack.
11.
12.
Do one of the following:
o
For tower models, install the bezel ("
" on page
o
For rack models, if removed, install the security bezel ("
" on page
Optical drive option
To install the component:
1.
Do one of the following:
o
For tower models, open and remove the bezel ("
" on page
o
For rack models, if installed, remove the security bezel (on page
2.
Power down the server (on page
3.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
4.
Do one of the following:
o
For tower models, place the server on a flat, level surface with the access panel facing up.
o