HP ProLiant ML350e Gen8 Server User Manual
Hp proliant ml350e gen8 server user guide
HP ProLiant ML350e Gen8 Server
User Guide
Abstract
This document is for the person who installs, administers, and troubleshoots servers and storage systems. HP assumes you are qualified in the
servicing of computer equipment and trained in recognizing hazards in products with hazardous energy levels.
Part Number: 679349-003
January 2013
Edition: 3
Table of contents
Document Outline
- HP ProLiant ML350e Gen8 Server User Guide
- Abstract
- Notice
- Contents
- Component identification
- Front panel components
- Rear panel components
- System board components
- Smart Array SAS RAID controller card components
- SAS and SATA device numbers
- SAS and SATA drive LED combinations
- FBWC module LED definitions
- Drive LED definitions
- Fan locations
- Redundant power supply backplane connectors
- T-10/T-15 Torx screwdriver
- Operations
- Power up the server
- Power down the server
- Remove the tower bezel
- Install the tower bezel
- Remove the security bezel
- Remove the rack bezel
- Install the rack bezel
- Remove the access panel
- Install the access panel
- Extend the server from the rack
- Remove the PCI air baffle
- Install the PCI air baffle
- Remove the system air baffle
- Install the system air baffle
- Remove the fan cage
- Remove a fan
- Remove the FBWC capacitor pack
- Remove the DVD drive
- Remove a component drive cage blank
- Remove a full-length expansion board
- Setup
- Optional installation services
- Rack planning resources
- Optimum environment
- Rack warnings
- Server warnings and cautions
- Identifying tower server shipping carton contents
- Installing hardware options
- Setting up a tower server
- Installing the server into the rack
- Powering up and configuring the server
- Installing the operating system
- Registering the server
- Hardware options installation
- Introduction
- Security bezel option
- Second processor option
- Memory options
- Memory configurations
- General DIMM slot population guidelines
- Installing a DIMM
- SAS drive options
- Optical drive cage option
- Optical drive option
- Installing a storage controller
- FBWC options
- Installing an expansion board
- Eight-bay SFF drive cage option
- Six-bay LFF drive cage
- Redundant Enablement Option
- Redundant power supply module
- Installing the LFF 5/6 drive cable option
- Tower-to-rack conversion option
- HP Trusted Platform Module option
- Cabling
- Software and configuration utilities
- Troubleshooting
- Battery replacement
- Regulatory information
- Electrostatic discharge
- Specifications
- Support and other resources
- Acronyms and abbreviations
- Documentation feedback
- Index