HP ProLiant ML350e Gen8 Server - Manual (Page 30)

Operations 30
b. Slide the server back into the rack.
4. Power up the server (on page 22 ).
5. Do one of the following:
o For tower models, install the bezel (" Install the tower bezel " on page 23 ).
o For rack models, if removed, install the security bezel (" Security bezel option " on page 47 ).
Remove the system air baffle
To remove the component:
1. Do one of the following:
o For tower models, open and remove the bezel (" Remove the tower bezel " on page 22 ).
o For rack models, if installed, remove the security bezel (on page 24 ).
2. Power down the server (on page 22 ).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
o For tower models, place the server on a flat, level surface with the access panel facing up.
o For rack models, extend the server from the rack (on page 27 ).
5. Remove the access panel (on page 25 ).
6. If installed, remove the PCI air baffle (on page 28 ).
7. Remove the system air baffle (" Remove the system air baffle " on page 30 ).
Install the system air baffle