HP ProLiant ML350e Gen8 Server - Manual (Page 37)

Operations 37
Remove a full-length expansion board
To remove the component:
1. Do one of the following:
o For tower models, open and remove the bezel (" Remove the tower bezel " on page 22 ).
o For rack models, if installed, remove the security bezel (on page 24 ).
2. Power down the server (on page 22 ).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. For tower models, do the following:
a. Place the server on a flat, level surface with the access panel facing up.
b. Remove the access panel (on page 25 ).
5. For rack models, do the following:
a. Extend the server from the rack (on page 27 ).
b. Remove the access panel (on page 25 ).
6. If installed, remove the PCI air baffle (on page 28 ).
7. Open the PCI slot cover retainer latch.