HP LaserJet Pro CM1415fnw Color Multifunction Printer - Manual (Page 41)

Network Setup menu
In the following table, items that have an asterisk (*) indicate the factory default setting.
Menu item Sub-menu item Description
Wireless Menu Wireless Setup Wizard Guides you through the steps to set up the product on a wireless
network
Wi-Fi Protected Setup If your wireless router supports this feature, use this method to set
up the product on a wireless network. This is the simplest method.
Run Network Test Tests the wireless network and prints a report with the results.
Turn Wireless On/Off Enables or disables the wireless network feature.
TCP/IP Config Automatic *
Manual
Automatic : The product automatically configures all the TCP/IP
settings via DHCP, BootP or AutoIP.
Manual : You can manually configure the IP address, subnet mask,
and default gateway. The control panel prompts you to specify
values for each address section. As each address is completed,
the product prompts for address confirmation before moving to the
next one. After all three addresses are set, the network reinitializes.
Auto Crossover On *
Off
Enables or disables the use of a standard 10/100 network cable
when the product is directly connected to a coomputer.
Network Services IPv4
IPv6
Enable or disable the IPv4 and IPv6 protocols. By default, each
protocol is enabled.
Link Speed Automatic *
10T Full
10T Half
100TX Full
100TX Half
Sets the link speed manually if needed.
After setting the link speed, the product automatically restarts.
Restore Defaults Resets all network configurations to their factory defaults.
ENWW Setup Menu 25