HP LaserJet Pro CM1415fnw Color Multifunction Printer - Manual (Page 235)

Control panel message Description Recommended action
No dial tone. The product could not detect a dial tone. Check for a dial tone on the phone line by
touching the
Start Fax button.
Unplug the telephone cord from both the
product and the wall and replug the cord.
Make sure that you are using the telephone
cord that came with the product.
Open the Service menu, and touch the Fax
Service button. Touch the Run Fax Test
button. This test verifies that the phone cord
is connected to the correct port and that the
phone line has a signal. The product prints a
report with the results.
If the error persists, contact HP. See
www.hp.com/support/CM1410series or the
support flyer that came in the product box.
No fax answer.
Canceled send.
Attempts to redial a fax number failed, or the
Redial if No Answer option was turned off.
Call the recipient to ensure that the fax
machine is on and ready.
Check that you are dialing the correct fax
number.
Check that the redial option is enabled.
Unplug the telephone cord from both the
product and the wall and replug the cord.
Open the Service menu, and touch the Fax
Service button. Touch the Run Fax Test
button. This test verifies that the phone cord
is connected to the correct port and that the
phone line has a signal. The product prints a
report with the results.
If the error persists, contact HP. See
www.hp.com/support/CM1410series or the
support flyer that came in the product box.
No fax answer.
Redial pending.
The receiving fax line did not answer. The
product attempts to redial after a few minutes. Allow the product to retry sending the fax.
Call the recipient to ensure that the fax
machine is on and ready.
Check that you are dialing the correct fax
number.
If the product continues to redial, unplug the
product telephone cord from the wall, plug in
a telephone, and try making a voice call.
Open the Service menu, and touch the Fax
Service button. Touch the Run Fax Test
button. This test verifies that the phone cord
is connected to the correct port and that the
phone line has a signal. The product prints a
report with the results.
If the error persists, contact HP. See
www.hp.com/support/CM1410series or the
support flyer that came in the product box.
Table 13-1 Control-panel messages (continued)
ENWW Interpret control-panel messages 219