Printer maintenance kit – HP LaserJet 9050 Printer series User Manual
Page 94
92 Chapter 5 Printer maintenance
ENWW
Printer maintenance kit
Note
The printer maintenance kit is a consumable and is not covered under warranty.
To ensure optimum print quality, HP recommends that the printer maintenance kit be used
approximately every 350,000 pages. You might need to replace the kit more often, depending on
the type of printing you do. If you have questions about how frequently you should use a
maintenance kit, contact the support center at
When the
PERFORM PRINTER MAINTENANCE
message appears on the control panel, you need to
purchase a printer maintenance kit and install the new parts. The part number for the 110-V kit is
C9152A. The part number for the 220-V kit is C9153A. The printer maintenance kit contains two
Type 1 rollers, seven Type 2 rollers, one transfer roller assembly, and one fuser assembly.
Complete instructions for installing the kit components are included in the printer maintenance kit
box.
After a new maintenance kit is installed, reset the printer maintenance count.
To reset the printer maintenance count
1
Turn the printer off.
2
Turn the printer on.
3
When the memory count starts, press and hold
.
4
When the three LEDs are on, press
until
NEW MAINTENANCE KIT
appears on the screen.
5
Press .
If the message persists,
1
Use
or
to scroll to
CONFIGURE DEVICE
.
2
Use
or
to scroll to
RESETS
.
3
Press .
4
Use
or
to scroll to
CLEAR MAINTENANCE MESSAGE
.
5
Press .
To verify that the maintenance kit is reset to zero, print a configuration page by using the
following procedure.
To print a configuration page
1
Press .
2
Use
or
to scroll to
INFORMATION
. and press
3
Use
or
to scroll to
PRINT CONFIGURATION
. and press
.
For more information about installing the printer maintenance kit, see the instructions that
accompany it.