HP LaserJet 9050 Printer series - Manual (Page 176)

174 Appendix B Control-panel menus ENWW
PERSONALITY=AUTO AUTO
PCL
PS
PDF
XHTML
MIME Select the default printer language (personality). Possible
values are determined by which valid languages are installed
in the printer.
Normally you should not change the printer language (the
default is
AUTO ). If you change it to a specific printer
language, the printer does not automatically switch from one
language to another unless specific software commands are
sent to the printer.
CLEARABLE
WARNINGS=
JOB ON
JOB Set the amount of time that a clearable warning appears on
the printer control panel.
ON : Warning messages appear on the control panel until
is pressed.
JOB : Warning messages appear on the control panel until the
end of the job from which they were generated.
AUTO CONTINUE=ON ON
OFF Determine how the printer reacts to errors.
ON : If an error prevents printing, the message is displayed,
and the printer goes offline for 10 seconds before returning
online.
OFF : If an error prevents printing, the message remains on
the display, and the printer does not print until is
pressed.
Note
To stop printing when out of staples (when a stapler
accessory is installed), set
AUTO CONTINUE=OFF on the
control-panel System setup menu.
CARTRIDGE LOW=
CONTINUE CONTINUE
STOP Determine how the printer functions when toner is low. The
CARTRIDGE LOW message first appears when the print
cartridge is almost out of toner. (About 2400 pages can still
be printed at 5% coverage.)
CONTINUE : The printer continues to print while the CARTRIDGE
LOW message is displayed.
STOP : The printer goes offline and wait for further action.
For more information, see Managing the print cartridge .
CARTRIDGE OUT=
CONTINUE STOP
CONTINUE Determine how the printer functions when toner is out.
JAM RECOVERY=
AUTO AUTO
ON
OFF Determine how the printer functions when a jam occurs.
AUTO : The printer automatically selects the best mode for
printer jam recovery (usually ON ). This is the default setting.
ON : The printer automatically reprints pages after a paper jam
is cleared.
OFF : The printer does not reprint pages following a paper
jam. Printing performance might be increased with this
setting.
LANGUAGE=ENGLISH List of
available
languages Sets the language that is used on the control panel.
Item Values Explanation