HP LaserJet 9050 Printer series User Manual
Page 123
ENWW
Resolving control-panel messages 121
INSERT OR
CLOSE TRAY xx
For help press
The specified tray must be inserted or closed for printing to continue.
INSTALL CARTRIDGE
For help press
The print cartridge has been removed or has been installed incorrectly. It must
be replaced or reinstalled correctly for printing to continue.
Insufficient memory
to load Fonts/Data
For help press
alternates with
[DEVICE]
To continue press
The printer does not have enough memory to load the data (for example, fonts
or macros) from the location specified. Touch
OK
to continue without this
information.
If the message persists, add more memory.
LOAD TRAY XX
[TYPE] [SIZE]
To use another tray
press
.
alternates with
LOAD TRAY XX
[TYPE] [SIZE]
For help press
A job is sent that requires a specific type and size that is not available.
Load the requested paper into optional Tray 1.
Press
to use a type and size that is available in another tray.
LOAD TRAY XX
[TYPE] [SIZE]
For help press
The tray is empty or is configured for a different size of paper than the size that
was requested.
MANUALLY FEED
[TYPE] [SIZE]
For help press
alternates with
To use another tray
press
.
Load the requested paper into optional Tray 1.
To override the message, press
if the desired paper is available in another
tray.
Press
to use a type and size that is available in another tray.
No job to cancel
The
S
TOP
button was pressed, but there is no active job or buffered data to
cancel.
The message appears for approximately two seconds before the printer returns
to the
READY
state.
NON-HP SUPPLY
INSTALLED
alternates with
Economode disabled
The printer has detected that the supply is not a genuine HP cartridge, and the
message appears for approximately 30 seconds before the printer is returned
to the
READY
state. If you think you purchased an HP print cartridge, go to
. Any printer repair that is required as a result
of using a non-HP print cartridge is not covered under the printer warranty.
ORDER CARTRIDGE
LESS THAN XXXX PAGES
For help press
The print cartridge is low and the
CARTRIDGE LOW
setting in the
SYSTEM SETUP
submenu is set to
CONTINUE
. Approximately 2 weeks of typical printing capacity
remains in the cartridge. This offers sufficient time to order a new cartridge.
Message
Explanation or recommended action