HP Insight Management Agents - Manual (Page 138)

The industry-standard addresses for serial ports are as follows:
•
COM1 set to 3F8h
•
COM2 set to 2F8h
These addresses are sometimes changed due to conflicts with another device. Communication
ports that have been disabled do not show up in this window.
Universal Serial Bus Port
This section displays the Universal Serial Bus (USB) ports that have been enabled for this unit.
Following information is displayed in the USB table:
•
Port—displays the USB port numbers.
•
Device Description—displays the device name when the USB device is attached to the port.
•
Status—displays the status of the USB device whether it is Present or Absent or Not Populated.
Default value is displayed as Not Populated against each available ports on this machine.
Memory Modules
This section lists detailed information about the memory boards and modules installed in the system.
The following items may be displayed:
•
Socket Number—displays the socket number for the memory module.
•
Type—displays the following values depending on the type of memory module selected.
Not installed ◦
◦ Board—The memory module is permanently mounted (not modular) on a system board
or memory expansion board.
◦ Single width module
◦ Double width module
◦ SIMM (Single Inline Memory Module)
◦
PCMCIA (Personal Computer Memory Card International Association technology memory
module)
◦ Compaq/HP specific memory module
◦ DIMM (Dual Inline Memory Module)
•
Size—Displays the size of the memory module.
•
Speed—Displays the speed of the memory module.
•
Technology—Displays the possible values for the memory module technology, including:
FPM (Fast-Page Mode) ◦
◦ EDO (Extended Data Out)
◦ BEDO (Burst Extended Data Out)
◦ Synch DRAM (Synchronous DRAM)
◦ Unknown
138 Agent information