HP Insight Management Agents - Manual (Page 120)

banks are duplicate. If more ECC errors occur, the system activates the spare memory
and disables the memory that receives the maximum errors.
◦ Mirroring Intersocket—Configure this system for Intersocket Mirrored Memory Protection.
In the Intersocket Mirrored Memory, except OnLine Spare Memory, all other memory
banks are duplicate. If more ECC errors occur, the system activates the spare memory
and disables the memory that receives the maximum errors.
Memory Summary
This section displays the information about the memory board or riser detail information.
•
Condition—Displays the current condition of the Advanced Memory Protection subsystem. The
following states are supported:
◦ Other—The system does not support fault tolerant memory or the Management Agent
cannot determine the state.
◦ Ok—This system is operating normally.
◦ Degraded—The Advanced Memory Protection sub-system has been engaged. Schedule
server down time to replace the deactivated memory.
•
Location—The Slots\CPU number in which the memory board or cartridge or raiser is installed.
System Board—There is no separate memory board slot, all DIMMs are installed on
system board itself. ◦
◦ Board Number—There is memory board slot available, all DIMMs are installed on the
memory board.
◦ CPU Number—This displays the CPU number to which the memory DIMMs are installed.
◦ Riser Number—This displays the riser number to which the memory DIMMs are installed.
•
Status—This provides the current status of the Advanced Memory Protection memory board
or cartridge or riser. The following status values are supported:
◦ Unknown—The value is unsupported or could not be determined.
◦ OK—The board or cartridge is configured and operating correctly.
◦ DIMM ECC Error—The board or cartridge has at least one DIMM ECC error.
◦ Unlock Error—The board or cartridge is unlocked when it should not be. Be sure that the
board of cartridge is locked.
◦ Configuration Error—The board or cartridge has a bad memory configuration. Be sure
that all memory modules are of the correct type, speed, latency, etc.
◦ Bus Error—The board or cartridge has a memory bus error. Please insure all memory
modules are of the correct type, speed, latency, etc. Be sure that the cartridge is inserted
properly.
◦ Power Error—The board or cartridge has power error. Please insure all memory modules
are of the correct type, speed, latency, etc. Also insure the cartridge is inserted properly.
◦ Advanced ECC—The board or cartridge is configured for advanced ECC mode.
◦ Online Spare—The board or cartridge is configured for Online Spare mode.
◦ Mirrored—The board or cartridge is configured for mirrored mode.
◦ Mirrored memory Error—The board or cartridge has a mirrored DIMM error.
120 Agent information