HP Insight Management Agents - Manual (Page 123)

PCI Devices
This section displays a list of expansion boards and their associated slot numbers. You can also
view System Resources that are used by each board. Use the Expansion Boards feature to keep
track of boards on the device and which resources are being used.
The Expansion Boards section provides additional information about PCI slots in the system, such
as the width and speed of the PCI slot.
Management Processor
Integrated Lights-Out (iLO) NIC
The NIC section displays the following information about the NIC in the iLO. Not all fields are
supported by all models of Remote Insight Board and/or NIC.
•
Model—Displays the NIC model.
•
DNS Name—Displays the fully qualified DNS name assigned to this iLO.
•
Type—Displays if the NIC is embedded or pcmcia and whether it is Ethernet or a token ring.
•
IPv4 Address—Displays the IPv4 address for this NIC.
•
IPv4 Subnet Mask displays the subnet mask for this NIC.
•
IPv4 Gateway—Displays the default gateway configured for this NIC.
•
IPv6 Address—Displays the IPv6 addresses configured for the iLO NIC.
•
Status—Displays if this NIC is enabled or disabled.
•
Physical Address—Displays the MAC address for this NIC.
•
Duplex—Displays if the controller is in half duplex, full duplex or does not support a duplex
state.
•
Link Status—Displays Remote Insight/Integrated Lights-Out Network Interface Controller
condition. The following values are possible:
◦ Other
◦ Ok
◦ Degraded
◦ Failed
•
Speed—Displays the speed of the NIC.
•
Max Packet Size—Displays the maximum packet size of the NIC.
•
Transmit/Receive Statistics—Displays the following set of statistics for the NIC:
•
Bytes—Displays the number of bytes transmitted/received.
•
Total Packets—Displays the number of packets transmitted/received.
•
Unicast Packets—Displays the number of unicast packets transmitted/received.
•
Non-Unicast Packets—Displays the number of non-unicast packets transmitted/received.
•
Discarded Packets—Displays the number of packets discarded during transmit/receive.
•
Error Packets—Displays the number of error packets found during transmit/receive.
•
Unknown Protocols—Displays the number of unknown protocol packets received.
•
Queue Length—Displays the number of outstanding packets in the transmit queue.
Sub-system Classification 123