Cabling the vls node – HP 12000 Virtual Library System EVA Gateway User Manual
Page 18
NOTE:
If your rack contains single phase PDUs:
•
Install up to four nodes in the first rack starting in position 35 working up the rack.
•
Install up to four nodes in the second rack starting in position 35 working up the rack.
If your rack contains 3–phase PDUs:
•
Install up to six nodes in the first rack starting in position 33 working up the rack.
•
Install up to two nodes in the second rack starting in position 33 working up the rack.
Cabling the VLS Node
Table 2 Cabling the Node
Connects to
Description
Item
Primary node: connects to your system's backend storage via FC cable.
FC port 4
1
Secondary nodes: connects to your system's backend storage via FC cable.
Primary node: connects to your system's backend storage via FC cable.
FC port 3
2
Secondary nodes: connects to your system's backend storage via FC cable.
Primary node: connects to your system's backup SAN via FC cable.
FC port 2
3
Secondary nodes: connects to your system's backup SAN via FC cable.
Primary node: connects to your system's backup SAN via FC cable.
FC port 1
4
Secondary nodes: connects to your system's backup SAN via FC cable.
Primary node: connects to port 1 of Ethernet switch #2 (SW2) via Ethernet cable.
NIC 4
5
Secondary nodes: connects to the next available port on Ethernet switch #2 (SW2)
via Ethernet cable. Cable secondary nodes to the switch ports 2 through 8 in
sequential order.
Primary node: connects to port 1 of Ethernet switch #1 (SW1) via Ethernet cable.
NIC 3
6
Secondary nodes: connects to the next available port on Ethernet switch #1 (SW1)
via Ethernet cable. Cable secondary nodes to the switch ports 2 through 8 in
sequential order.
Primary node: connects to your system's external network via Ethernet cable.
NIC 1
7
Secondary nodes: connects to your system's external network when using replication
via Ethernet cable.
NOTE:
Not all systems use all of the components listed in
The primary node, node 0, is on the bottom of the stack of nodes. From the bottom to the top they
are: node 0, node 1, node 2, node 3. (The number of nodes will vary from system to system.)
1.
Cable the primary node (node 0) and secondary node (node 1) using
.
18
Hardware Installation