HP StorageWorks 3000 RAID Array - Manual (Page 97)

Installation and Maintenance 3-35
Compaq Confidential – Need to Know Required
Writer: Bob Young Project: RAID Array 3000 Controller Shelf Hardware User’s Guide Comments:
Part Number: EK-SMCPQ-UG. D01 File Name: d-ch3 Installation and Maintenance.doc Last Saved On: 12/4/00 1:08 PM
Figure 3-21 shows how to remove the installed SIMM module.
Figure 3-21. Remove installed SIMM modules
CAUTION: Ensure that “ side 1 ” of the two replacement SIMMs is facing you
when installing the modules in the following step.
5. Install the two replacement memory modules by aligning the module
and connector pins (check alignment guide in center of module) and
gently pivot the module into the main controller board until it snaps into
place (see Figures 3-19 and 3-20).
6. Replace the controller into the shelf.
7. Power On the UPS and then power On the controller shelf.