HP StorageWorks 3000 RAID Array - Manual (Page 71)

Installation and Maintenance 3-9
Compaq Confidential – Need to Know Required
Writer: Bob Young Project: RAID Array 3000 Controller Shelf Hardware User’s Guide Comments:
Part Number: EK-SMCPQ-UG. D01 File Name: d-ch3 Installation and Maintenance.doc Last Saved On: 12/4/00 1:08 PM
10. Install two shelf retainer brackets (item 1, Figure 3-5) to the left and
right rails of the cabinet and secure with two screws. The controller
shelf is now safely mounted in the cabinet.
Installing Shelf Supports in a RETMA Cabinet
(Square Hole)
Use the following procedure to install the shelf supports into a RETMA
cabinet with square holes in the mounting rails (see Figure 3-5).
1. Open the kit and ensure it contains the items listed in Table 3-2.
2. Retrieve six washers (part no.: 90-06664-00) from general packaging.
3. Determine the mounting location in your cabinet.
4. Install the left shelf support by aligning the support and cabinet rail
holes and then securing the support to the cabinet using three screws
(item 7, Figure 3-5) and washers. Tighten the screws.
5. Repeat steps 3 and 4 to install the right shelf support in the cabinet.
Align the support with the left unit and tighten the screws.
6. Install the support bracket (item 6, Figure 3-5) by securing the bracket
studs with two plate nuts (item 8, Figure 3-5).
7. Install a shelf retainer bracket (item 1, Figure 3-5) in the rear slot of the
left shelf support and secure with two screws.
8. Repeat step 7 to secure a shelf retainer bracket to the right shelf support.
9. Place the Controller shelf on the cabinet shelf supports and slide the
shelf completely to the rear of the cabinet.